Subaru Remanufactured Alternator Information Quality provided by Southern Oregon Subaru in Medford
Subaru Service Center for Car Repair & Maintenance Specials & Discount Coupons at Southern Oregon Subaru in Medford Subaru Auto Parts Center for Accessories Specials & Discount Coupons at Southern Oregon Subaru in Medford Subaru Service Coupons, Car Repair & Maintenance Discount Specials at Southern Oregon Subaru in Medford Subaru Parts Specials & Accessories Discount Coupons at Southern Oregon Subaru in Medford Subaru Service Schedules for Car Repair & Maintenance at Southern Oregon Subaru in Medford Image Map

Subaru Remanufactured Alternators

Since alternators are typically subjected to severe temperature extremes, dust and stress, restoring one to like-new condition requires total disassembly and complete cleaning. All major components are thoroughly tested for proper operation.

Any parts found to be out of OEM specification are replaced with new. Many external parts are replaced to provide maximum resistance to corrosion. After complete reassembly, the remanufactured alternator must pass thorough output power and "load" tests.

Front Housing

Cleaned, inspected and retapped to Subaru specifications; replaced with new Genuine Subaru component as needed to return dimensional part to OEM specifications. (Properly installed housings with the drain hole correctly located allow moisture drainage.)

Armature

Continuity performance tested; replaced with new Genuine Subaru component as needed to meet OEM Subaru specifications.

Pulley

Checked for damage and refinished or replaced as required.

Bearings

Replaced 100% with new Genuine Subaru front and rear bearings for long-life operation like a new unit.

Stator

600 volt performance tested; replaced with new Genuine Subaru component as needed to confirm insulation integrity and help ensure that unit performs to Subaru specification.

Terminals and Insulators

Replaced 100% with new Genuine Subaru components to provide proper conductivity and insulation where needed to help prevent unit failure.

Commutator

Remachined to average 8 micron runout - maximum 20 micron. Avoids brush bounce and helps to provide consistent voltage output to ensure unit meets Subaru OEM specifications.

Voltage Regulator

Replaced 100% with new Genuine Subaru component to provide long-life by meeting the latest OEM specifications.

Rectifier / Diodes

300 volt performance tested to Subaru specifications; replaced with new Genuine Subaru components to help ensure long-life by meeting the latest, most efficient OEM specifications.

Rear Housing

Refinished to Subaru specifications; replaced with new Genuine Subaru components as needed to provide necessary insulation and corrosion protection.

Brushes, Springs and Brush Holder

Replaced 100% with new Genuine Subaru components as brushes are a wear item and spring replacement helps prevent brush bounce which could lead to rapid wear.

Hardware

New or zinc/yellow chromate plated to provide necessary corrosion protection and superior finish appearance.
remanufactured subaru alternator